Click here to Download a Printable PDF of this Page

Standard Service Plan for one unit

$209 per year

  • Gas Furnace
  • Gas Boiler
  • Gas Water Heater
  • Heat Pump
  • Oil-Fired Furnace
  • Oil-Fired Boiler
  • Oil-Fired Water Heater
  • Air Conditioner
Each additional unit at the same location add: $130
With additional water heater: add $100
With humidifier: add $50
With TankSure: add $50

Subject to General Conditions. (Click To View)

Annual Tune-Up & Inspection

All units must be inspected at the same time. The scheduling of the annual tune-up is the customer's responsibility and it must be done during the service plan period. (See General Conditions, paragraph 3)

Heating

Clean and adjust the burner, oil motors, vacuum heat exchanger, clean chimney base, if accessible, install new oil burner nozzle, new oil filter cartridge, new oil burner pump strainer. Check combustion efficiency if applicable.

Air Conditioner or Heat Pump

Clean evaporator coil, condenser coil, condensate drains; check air temperature across evaporator and condenser, contactors, relays, compressor and refrigerant pressure and filters; inspect wiring, pulleys and belts, system safety devices and air handling unit, test for proper voltage, check vibration and noise; lubricate bearings and motors.

Service Calls

Provides 24-hour emergency "No Heat" service on parts and labor listed below at "NO CHARGE" to you. All routine service calls will be performed during regular working hours. (Monday-Friday, 8 a.m. to 5 p.m.).

Labor Coverage & Replacement of the following (which may need replacing due to normal wear):
air tubeappliance gas valve: ($50 part allowance)aquastat ($100 part allowance)blower bearings
blower drive beltblower motor ($100 part allowance)blower pulleyblower wheel
cadcell and holdercirculator couplingcondenser fan motor ($100 part allowance)contactor (up to 50 amp)
draft regulatorelectrodes and leadsfan control centerfan and limit control
fan relayflare fittingsgas electronic ignition control ($50 allowance)gas flame rollout switch
gas flame sensorgas ignitergas pressure switchgas thermal couple
high pressure controlnon-programmable low voltage thermostatoil burner fanoil burner fuel pump
oil burner headoil burner ignition transformeroil burner motoroil burner motor coupling
oil burner nozzleoil burner nozzle lineoil burner pump straineroil filter cartridge
oil line valveoil tank gauge vialprimary controlrefrigerant
run capacitorstart capacitorlow voltage transformer, 24 volt 

Replacement parts NOT listed will be charged at our prevailing rates on Standard Plans. Labor on non-covered calls for equipment covered by the Standard Plan will receive a 20% discount.

Terms of document apply to all Standard Service Plans starting or renewing during:
July 1, 2010 through June 30, 2011.

Besche describes all service plan options for Carrier, Trane, Thermo Pride, Columbia, Honeywell, Armstrong Air, Bock, and Energy Kinetics for air-conditioning, heat pump, boiler, furnace, or hot water systems.

Besche’s Southern Maryland customers have a wide range of quality service plans options from which to choose. Expert, factory-trained service technicians are available for every Besche Home Heating, Heat Pump, or Air-conditioning system service requirement in Calvert, Charles, St. Mary’s, Anne Arundel, and Prince Georges Counties.

Heating – Clean and adjust major oil burner parts, install nozzle, filter, and pump strainer. Air Conditioner or Heat Pump- Clean, lubricate, and inspect major parts. Service Calls - Provides 24-hour emergency "No Heat" service on parts and labor listed. Labor Coverage and Replacement of listed Parts. See the actual plan for details.

Besche’s mission is to deliver to Southern Maryland customers, quality products and services including Heating Oil, K 1 Kerosene, Carrier and Trane HVAC systems, at competitive prices, in an environmentally sound manner. Besche provides opportunities for its employees to contribute to the well being of the community.