Super Service Plan for one unit

$269 per year

Gas Furnace
Gas Boiler
Gas Water Heater

Oil-Fired Furnace
Oil-Fired Boiler
Oil-Fired Water Heater

Heat Pump
Air Conditioner

Each additional unit at the same location add: $150

With additional water heater: add $100

With humidifier: add $50

With TankSure: add $50

Subject to General Conditions. (Click To View)

Annual Tune-Up & Inspection

All units must be inspected at the same time. The scheduling of the annual tune-up is the customer's responsibility and it must be done during the service plan period. (See General Conditions, paragraph 3)

Heating

Clean and adjust the burner, oil motors, vacuum heat exchanger, clean chimney base, if accessible, install new oil burner nozzle, new oil filter cartridge, new oil burner pump strainer. Check combustion efficiency if applicable.

Air Conditioner or Heat Pump

Clean evaporator coil, condenser coil, condensate drains, check air temperature across evaporator and condenser, contactors, relays, compressor and refrigerant pressure and filters; inspect wiring, pulleys and belts, system safety devices and air handling unit, test for proper voltage, check vibration and noise; lubricate bearings and motors.

Service Calls

Provides 24-hour emergency "No Heat" service on parts and labor listed below at "NO CHARGE" to you. All routine service calls will be performed during regular working hours. (Monday-Friday, 8 a.m. to 5 p.m.)

Weekend Labor Coverage on Air Conditioning Calls (See General Conditions, paragraph 4)

Water Heater Allowance

Water Heater Replacement ($200 allowance off quoted price if installed by Besche).

Labor Coverage & Replacement of the following (which may need replacing due to normal wear):

above ground tank whistle	access valve caps	air-band	air scoop
anti-hum device	appliance gas valve	aquastat	back-flow preventer
blower bearings	blower drive belt	blower drive pulley	blower motor
blower motor adjustment screw	blower pulley	blower rubber mounts	blower shaft
blower threaded rubber motor mount	blower thrust collar	blower wheel	cadcell and holder
capacitors	cartridge fuse	check valves	circulator (complete)
circulator bearing assembly	circulator coupling	circulator impellar	circulator motor
circulator motor mounts	combustion chamber	complete oil filter assembly	computerized control board
condenser fan blade	condenser fan motor	condensate pump	condensate line
contactor (up to 50 amps)	crankcase heater	defrost board	draft prover switch
draft regulator	electrodes & leads	evacuation of system	expansion extrol tank
expansion filltrol tank	expansion tank	expansion therm-x-trol absorber	fan bracket
fan control center	fan and limit control	fan relay control	fill cap flare fittings
flow control valve	flue pipe (where accessible)	fuel pump bleeder	fuses
gas electronic ignition control	gas flame rollout switch	gas flame sensor	gas igniter
gas inducer draft motor	gas orifice	gas pilot assembly	gas pressure switch
gas thermal couple	general purpose relay	high pressure control	hydronic automatic air vent
isolation relay	limit control (high)	limit control (low)	low pressure control
low voltage transformer 24 volt	low water cut-off float	low water cut-off switch	multi-aquastat
nitrogen gas	non-programmable low voltage thermostat	nozzle adapter	nozzle line filter
oil burner air tube	oil burner fan	oil burner flange gasket	oil burner fuel pump
oil burner head	oil burner nozzle assembly	oil burner pump strainer	oil burner ignition transformer
oil burner motor	oil burner motor coupling	oil burner nozzle	oil burner nozzle line
oil burner solenoid valve	oil delay valve	oil filter cartridge	oil in-line cut-off valve
oil line (exposed)	oil tank gauge	oil tank gauge vial	pressure relief valve
primary control	pyrostat control	rain shield	refrigerant
refrigerant recovery	rods (brasing)	run capacitor	sailswitch control
service switch	service valves	stack relay control	start capacitor
switching relay	system 2000 manager	tiger loop de-aerator	time delay relay
torch (brasing)	vent cap	water feed valve	zone valve
zone valve motor	zone valve power head

Replacement parts NOT listed will be charged at our prevailing rates on Super Plans. Labor on non-covered calls for equipment covered by the Super Plan will receive a 20% discount.

Terms of this document apply to all Super Service Plans starting or renewing during:
July 1, 2010 through June 30, 2011.

Besche describes all service plan options for Carrier, Trane, Thermo Pride, Columbia, Honeywell, Armstrong Air, Bock, and Energy Kinetics for air-conditioning, heat pump, boiler, furnace, or hot water systems.

Besche’s Southern Maryland customers have a wide range of quality service plans options from which to choose. Expert, factory-trained service technicians are available for every Besche Home Heating, Heat Pump, or Air-conditioning system service requirement in Calvert, Charles, St. Mary’s, Anne Arundel, and Prince Georges Counties.

Heating – Clean and adjust major oil burner parts, install nozzle, filter, and pump strainer. Air Conditioner or Heat Pump- Clean, lubricate, and inspect major parts. Service Calls - Provides 24-hour emergency "No Heat" service on parts and labor listed. Labor Coverage and Replacement of extended list of parts. See the actual plan for details.

Besche’s mission is to deliver to Southern Maryland customers, quality products and services including Heating Oil, K 1 Kerosene, Carrier and Trane HVAC systems, at competitive prices, in an environmentally sound manner. Besche provides opportunities for its employees to contribute to the well being of the community.